Toshiba TEC MA-1300 - Manual (Page 92)

EO1-11064
15. PAPER ROLL REPLACEMENT AND OTHER
MAINTENANCE OPERATIONS
Journal Winding Reel
—p f
/ N
Fig. 2
15-1 INSTALLING THE RECEIPT PAPER
1. Turn the Mode Lock to the REG position with the
power ON.
2. Remove the Paper Cover, and remove the Journal
Winding Reel (Fig. 1).
3. Before you install a new paper roll, the paper end
should be cut with a knife or scissors for easy
insert!on.(Fig. 2)
4. Hold a new paper roll in the direction shown in Fig. 3
so that the paper end will be fed from the bottom.
5. Place the paper roll in the outer holder of the two roll
holders (Fig. 4).
6. Insert the paper end into the Receipt Inlet, then feed
the paper by pressing the [RF] key. (Fig. 5)
7. When the paper end portion comes out enough, tear
off the unnecessary part with attached cutter. (Fig. 6)
8. Go on to INSTALLING THE JOURNAL PAPER steps if
necessary, or go on to Step 9 below if not.
9. Attach the Paper Cover.
10. Depress the [NS] key to issue a receipt to check if the
paper has been properly set.
NOTE: The [RFJ or [JF] keys function only when both
receipt and journal paper rolls have been placed
in their respective holders.
- 8 8 -