Toshiba TEC MA-1300 - Manual (Page 74)

EOI-11064
STORE NAME /MESSAGE AND COMMERCIAL MESSAGE
PROGRAMMING OR CHANGING (Submode No. 1)
Any time outside a sale
Mode Lock: SET
Repeat for another line.
^ [@/FOR]
Submode No.
Line No. I [ST] -----------------------
1 to3
O'' (See NOTE 2 below.)
1 to 7
Character Entries
(Max. 18 characters for each
line; see CHARACTER
ENTRIES, on page 66.)
[ST] > [AT/TL]
Indicates the end of a line.
(Any unprogrammed parts of a line end will be
filled with blanks.)
For sequentially programming lines, the line number specification can be skipped.
NOTES: 1. For each line, a maximum of 18 regular-sized characters or 9 double-sized characters
may be entered. A combination of both types is also available.
2. If the option “Store Name Print by RUBBER STAMP“ is selected, no data can be
programmed for the store name/message. Therefore, enter 1 to 3 as Une No. for the
commercial message data only.
If the option “Store Name Print by DOT PRINTER” is selected, use 1 through 4 for the
store name/message and 5 through 7 for the commercial message data, as Line No.
3. If no commercial message is required on the receipt, program blanks for all three
lines. As a result no extra lines will be fed. If any one of the three lines is
programmed, the two other lines will cause line feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed, as
long as the option “Store Name print by DOT PRINTER” is selected.
5. If any incorrect characters have been programmed, depress the [C] key to clear all
the characters on a line and then re-enter characters from the beginning, or end the
line with an [ST] and re-program the entire line. The new data wilt be active.
6. When all the lines have been programmed, do a check by issuing a receipt. Only the
lines with errors need to be re-programmed; other lines will not be affected.
-
70 -