Plu table programming or changing (submode no. 4), Dept, Plu table programming or changing – Toshiba TEC MA-1300 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11064
PLU TABLE PROGRAMMING OR CHANGING (Submode No. 4)
^
time outside a sale.
To program new PLUs :
To change any programmed contents of
PLUS (except the following case):
To change programmed contents of PLUs ”1
dm
i
q
with sales data not zero.
J
Mode Lock : SET
4 [@/FOR] -r-^ I PLU Code I [PLU]
1 to 999
(STEP (A))
(STEP(B)) —I
I Preset Price I
max. 6 dig.
[AMT] ------------
for open PLUS
[DEPT]
linked
Dept
-►Character Entries for
[ST]
FLU’S Name
(max. 12 characters
see CHARACTER
ENTRIES,
page 66.)
to end the
PLU name
Repeat for another PLU. (max. 300 PLUs)
[AT^L]
*
" ' PLU Code I
[PLU]’
entry may be skipped if the PLU Code is sequential from that of
the PLU just set.
If this PLU code entry is skipped at very first PLU, the PLU code will automatically
programmed as PLU No. 1.
NOTES : 1) The Positive/Negative, Single-item/Itemized, Taxable/Non-taxable status are determined
by those of the department to which each PLU is linked.
2) STEP (A) may be omitted if only the PLU name is set or changed. Likewise, STEP
(B) may be omitted if the PLU name is not set or changed.
3) If no name is set for a PLU, the PLU Code (such as “PLU 001“) will be printed as the
PLU name on sales receipts.
4) An error results at entry time if the linked department is an other income department.
- 7 4 -