Toshiba TEC MA-1300 - Manual (Page 94)

EOl-11064
15-5 REPLACING THE RIBBON
CARTRIDGE
If either the receipt or journal print is too light, replace the
Ribbon Cartridge in the following manner.
1. Remove the Paper C o v e r .
2. Raise the Main Table with pushing the levers forward.
(Hg. 1 )
3. Life up the right edge of the old Ribbon Cartridge with
pushing the cartridge leftward. (Fig. 2)
4. Install a new Ribbon Cartridge in the reverse order to
Step 2 above (Fig. 3),
After setting the Ribbon Cartridge, turn the Ribbon
Cartridge Knob clockwise until the slack is taken up.
5. The Ribbon Cartridge is a consumable product. Be
certain to use a genuine Ribbon Cartridge supplied by
your TEC representative.
15-6 REPLENISHING THE STORE NAME
STAMP WITH INK
When the store name stamp is printed too lightly, replenish
the ink in the following manner:
1. Turn the Power Switch to OFF.
Cover.
Remove the Paper
2. Hold the protruding part of the Store Name Stamp
between your fingers, then pull it rightward. (Fig. 4)
3. Apply ink to the pad on the rear side of the Store
Name Stamp. The amount applied should be adjusted
according to the desired darkness of the printed
message, but the limit of 2 cc should not be exceeded.
(The Ink bottle supplied contains 5 cc of ink.) (Fig.5)
4. Follow the reverse order of the instructions in Step 2,
and then attach the cover.
Stamp
Stamp
Fig. 5
- 90 -