Toshiba TEC MA-1300 - Manual (Page 93)

EOM1064
15-2 REMOVING THE RECEIPT PAPER
1. Remove the Paper Cover.
2. Pull the paper core straight upward, {or cut the paper
at the rear, then remove the remaining paper end
portion by pressing the [RF] key.) (Fig. 7)
15-3 INSTALLING THE JOURNAL
PAPER
1. Turn the Mode Lock to the REG position with the
power on.
2. Remove the Paper Cover by pulling it upward, and
remove the Journal Winding Reel. (Fig. 1)
3. Follow Steps 3 and 4 of INSTALLING THE RECEIPT
PAPER procedure on the preceding page.
4. Place the paper roll in the inner roll holder of the two
holders.
5. Insert the paper end into the Journal Inlet, then feed
the paper by pressing the [JF] key. (Fig. 8)
6. When a sufficient amount of paper comes out, wind
the paper around the Journal Winding Reel two or
three times, and set the Journal Winding Reel into the
Reel Holder. (Fig. 9)
7. Attach the Paper Cover.
15-4 REMOVING THE JOURNAL PAPER
1. Remove the Paper Cover.
2. Press the [JF] key to wind up enough of the journal
paper, and then tear off the paper, holding the Journal
Winding Reel.
3. The wound-up portion of the paper can easily be
removed from the Reel by pulling it sideways. (Fig.
10 )
4. If enough paper remains on the roll, follow Steps 6 and
7 above; if the paper is running out, follow Steps 1
through 7 above.
NOTE: The [JF] or [RF] keys function only when both
journal and receipt rolls have been placed in
their respective holders.
- 8 9 -