Display, Numeric display – Toshiba TEC MA-1300 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EO1-11064
5. DISPLAY
The Operator’s Display (front display) is located at the top of the register just above the keyboard.
The Customer’s Display may be used as Rear Display if it is kept in the receptacle or used as
Remote Display if it is stretched up and turned to the required direction. The display has two types
of display - - numeric display and message descriptors.
OPERATOR’S DISPLAY
PLU
DPT
RPT
AMOUNT
_
1
_
_
_ __
l~l 1
—i
—i
—i
1
1
/
1
(_/
/_/ /
/
/
/ !_/
V V
V
V
V
V
V
V
V
V V
S I P
ALM
REG
(■)
TXBL
ST
TL
CG SHORT
CUSTOMER’S DISPLAY
NUMERIC DISPLAY
AMOUNT (8 digits) :
DPT (2 digits) :
RPT (1 digit) :
Displays the numeric data, such as amount, quantity, etc.
Displays the code which represents each Department key.
when repeating the same department entry.
It stays lit
Displays the repeat count of the same item. The count is indicated
from the second entry on, and only the last digit will be displayed even if
the count exceeds nine.
PLU (3 digits; the DPT and RPT digits are used for this purpose.):
Displays the PLU code when any PLU is entered,
repeating the same PLU entry.
It goes out when
- 5 -