Hazard warning flashers, Hazard warning flashers on, Hazard warning flashers -5 – GMC 2011 Sierra User Manual

Page 221

Advertising
background image

Black plate (5,1)

GMC Sierra Owner Manual - 2011

Lighting

6-5

The DRL and automatic headlamp
system are only affected when the
light sensor detects a change in
lighting lasting longer than the
delay.

If the vehicle is started in a dark
garage, the automatic headlamp
system comes on immediately.
Once the vehicle leaves the garage,
it takes approximately one minute
for the automatic headlamp system
to change to DRL if it is bright
enough outside. During that delay,
the instrument panel cluster may
not be as bright as usual. Make
sure the instrument panel brightness
control is in the full bright position.
See Instrument Panel Illumination
Control on page 6‑7
.

To idle the vehicle with the
automatic headlamp system off,
turn the control to the off position.

The headlamps will also stay
on after you exit the vehicle.
This feature can be programmed
using the Driver Information Center
(DIC). See Vehicle Personalization
(with DIC Buttons) on page 5‑52
.

If the vehicle is not equipped
with DIC buttons, exit lighting
is automatic. When it is dark
enough outside, the exterior lamps
remain on for 30 seconds after the
ignition is moved from ON/RUN to
LOCK/OFF.

For vehicles without a radio, the
instrument panel light remains on
for 30 seconds with the driver door
closed. For vehicles with a radio,
the instrument panel light remains
on for 10 minutes with the driver
door closed. See Retained
Accessory Power (RAP) on
page 9‑40
.

The regular headlamp system can
be turned on when needed.

Hazard Warning Flashers

|

(Hazard Warning Flashers):

Press this button located on top of
the steering column, to make the
front and rear turn signal lamps
flash on and off. This warns others
that you are having trouble. Press
again to turn the flashers off.

When the hazard warning flashers
are on, the vehicle's turn signals will
not work.

Advertising