GTCO QuikRuler - Users Guide User Manual
Page 25
QuikRuler 25
for an entire floor of an office building. You want to add 5 percent to the measurement, to
account for waste, mistakes and so on. You would follow these steps:
Measure the area where carpeting is required.
Click on the
buttons.
Select the
button to display the total.
You can also use the menu as a traditional calculator to add, subtract, multiply and divide
numbers independently of your measurements. You can do this at any time, even while
using QuikRuler functions.
Editing Data on the Display
QuikRuler provides several ways of editing and correcting the data on the display.
Correcting Mistakes When Accumulating Measurements
When you are accumulating measurements for areas and lengths, use the
function to clear the current measurement. In addition, you can use this function to
correct mistakes made while accumulating measurements.
Follow the steps below when you need to fix a mistake that occurred while you were
adding the measurements of several areas. You can use the same procedure to fix
mistakes made while accumulating measurements for lengths.
Select
to clear the area you are currently measuring from the QuikRuler
III display.
Choose
QuikRuler displays the size of the area you have already calculated.
Measure the next area and select
to display the total if you are done.