GTCO QuikRuler - Users Guide - Manual (Page 9)

QuikRuler 9
When QuikRuler is shipped to you, it is programmed to expect the menu to be in the lower
left corner of the digitizer surface.
Relocating the Menu at Start-Up
When you start QuikRuler, it shows the following message for five seconds.
If you want the menu to be in a different location, you can relocate it when you start
QuikRuler.
 Select a place for the menu and tape it down. The entire menu must be within the
digitizer’s measuring area.
 Power up QuikRuler.
 Press the stylus tip anywhere when the Relocate Menu message is displayed.
 QuikRuler prompts you to Select Left Pnt.