GTCO QuikRuler - Users Guide - Manual (Page 6)

QuikRuler 6
Display Module Connections
Optional PC Connections and Program Installation
To use QuikRuler with a PC, you must attach the interface module to an available PC serial
port and install the QuikRuler interface program.
 Insert the QuikRuler disk into drive A (or B).
 Type a:install (or b:install) at the DOS prompt and press ENTER.
 Follow the instructions on your screen.
Starting QuikRuler
QuikRuler starts up when you connect the power supply. If the start-up was successful,
you should hear four short beeps from the digitizer and after the sign-on messages, line 1
of the display should read “Select from Menu.” Line 2 of the display will show the current
X-axis and Y-axis position of the stylus and a number indicating the status of the stylus