HONDA 2004 Odyssey - Owner's Manual - Manual (Page 130)

CONTINUED
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction in
AM is not available.
You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and
(EX and EX-L models).
Use the TUNE bar or
knob to tune the radio to a desired
frequency. Press the
/ side
of the bar or turn the knob to the
right to tune to a higher frequency,
or press the
/ side or turn
the knob to the left to tune to a lower
frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
/ or /
side of the bar, or push the
SEEK switch up or down, then
release it.
The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. SCN/SCAN shows in
the display. The system will scan for
a station with a strong signal. When
it finds a strong signal, it will stop
and play that station for about 5
seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 5 seconds. When it
plays a station that you want to listen
to, press the SCAN button again.
Playing the Radio
Comf ort and Convenience Features
To Play the Radio To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
TUNE
SEEK
SCAN
127
Main Menu Table of Contents