HONDA 2004 Odyssey - Owner's Manual - Manual (Page 225)

To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, and turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender.
Pull the inner fender cover away
from the fender and bumper.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Remove the burned out bulb from
the socket by pushing it in and
turning the bulb counterclockwise
until it unlocks.
Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Put the inner fender cover in place.
Install the two holding clips. Lock
each one in place by pushing on
the center.
1. 2.
3.
5.
6.
7.
8.
4.
9.
Lights
Maintenance
Replacing the Front Side Marker/
Turn Signal and Parking Light
Bulb
222
HOLDING CLIP
Main Menu Table of Contents