HONDA 2004 Odyssey - Owner's Manual - Manual (Page 226)

Open the tailgate. Release the
covers by inserting a flat-tip
screwdriver into the slot until the
cover bows slightly. Then pivot
the screwdriver 90° and pull it
straight out of the slot.
Use a Phillips-head screwdriver to
remove the taillight assembly
mounting screw under each cover.
Pull the taillight assembly out of
the body by sliding it backward.
Determine which of the two bulbs
is burned out: stop/taillight/side
marker light or turn signal light.
Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
When reinstalling the taillight
assembly, align and pop the snap
fasteners in place. Tighten the two
mounting screws and reinstall the
covers in place.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Lights
Maintenance
Replacing Rear Bulbs
(in Fenders)
223
Main Menu Table of Contents