HONDA 2004 Odyssey - Owner's Manual - Manual (Page 174)

Pull the support rod out of its clip
and insert the end into the hole on
the driver’s side of the hood.
Lift it up slightly to remove the
support rod from the hole. Put the
support rod back into its holding clip.
Lower the hood to about a foot (30
cm) above the fender, then let it
drop. Make sure it is securely
latched.
Wait a few minutes after turning the
engine off before you check the oil.
Remove the dipstick (orange
handle).
Wipe off the dipstick with a clean
cloth or paper towel.
Insert it all the way back in its hole.
Remove the dipstick again and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see
on page .
1.
3.
2.
3.
4.
211
Bef ore Driving
To Close the Hood:
Oil Check
Adding Oil
Service Station Procedures
171
DIPSTICK
SUPPORT ROD
UPPER MARK
LOWER MARK
Main Menu Table of Contents