Interlogix MC355-1T/1S User Manual - Manual (Page 10)

6 IFS MC355-1T/1S User Manual
LED Indicators
LED Color Function
P1 Green Lit Indicates that power 1 has power.
P2 Green Lit Indicates that power 2 has power.
FAULT Green Lit Indicates that either power 1 or power 2 has no power.
Lit
Indicates that the Fiber Optical Port is successfully
connecting to the network at 1000Mbps.
Fiber LNK /ACT Green
Blinks
Indicates the Fiber Optical Port is receiving or sending
data.
TP 1000 Lit
Indicates that the Gigabit Ethernet Port is successfully
connecting to the network at 1000Mbps. OFF indicates
that the Gigabit Ethernet Port is successfully connecting
to the network at 10/100Mbps.
Lit
Indicates that the Gigabit Ethernet Port is successfully
connecting to the network at 10/100/1000Mbps.
TP LNK /ACT
Green
Blinks
Indicates that the Gigabit Ethernet Port is receiving or
sending data.
Note: Pressing and releasing the RESET button will revert the settings to the
factory default mode. Be sure that you backup the latest configuration of MC355-
1T/1S; or else the entire configuration will be lost after the unit is reset.
Press and release the RESET button quickly, the device will reboot.
Press the RESET button about 10 seconds and release, the device will be set to
the factory default mode.
Top Panel
The top panel of the MC355-1T/1S consists of a terminal block connector with
two DC power inputs. Figure 2 shows the top panel of the MC355-1T/1S.
Figure 2: Top Panel
Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of the MC355-1T/1S is
used for two DC redundant power supply inputs. Please follow the steps below to
insert the power wires.