Interlogix MC355-1T/1S User Manual - Manual (Page 52)

48 IFS MC355-1T/1S User Manual
to send a dying gasp event notification OAMPDU. All the other functions defined
by 802.3ah are implemented using the embedded CPU.
When the remote device is in loop back mode, the hardware can support
changing the looped test frame’s DA, SA or both as user defined. Hardware can
also be set to not change looped test frame.
This function provides 802.3ah Setup of the MC355-1T/1S. Press the “Apply”
button to save the latest configuration of the MC355-1T/1S.
Figure 44: 802.3ah Setup Web Page screen
The 802.3ah Setup Web page includes the following configurable data:
802.3ah OAM State Disable or enable the 802.3ah OAM State function. Default mode is
Enable.
802.3ah OAM Mode Choose “Active” or “Passive” for 802.3ah OAM Mode. Default mode
is Passive.
Loopback Reply Disable or enable the Loopback Reply function. Default mode is
Enable.
Remote OAM Configure Disable or enable the Remote OAM Configure function. Default mode
is Enable.
Remote OAM
Configuration Result Displays the Remote OAM Configuration Result.
Apply Button Press this button to save the latest configuration of the MC355-
1T/1S.
Note: The 802.3ah function requires a managed device that also supports
802.3ah function.
Please use the MC355-1T/1S as the remote device.