Juniper Systems Trimble Lassen GPS Expansion Pod - Manual (Page 4)


Field PC GPS Expansion Pod
7.
Attach the antenna on the antenna bracket.
8.
Remove the protective cap from the connector
labeled GPS ANT (save the cap for future use). Screw
the antenna cable into the Expansion Pod.
You have completed the steps to attach the antenna
bracket to the Field PC GPS Expansion Pod.
GPS Pod Setup Program
The GPS Pod Setup program is factory installed on
your Field PC. The program allows you to configure the
parameters of the internal GPS receiver to accommodate
the various GIS/GPS programs that run on the Field PC.
The Field PC communicates with the internal GPS
receiver. The GPS Pod Setup program allows you to
change the serial port settings being used (i.e. baud rate,
parity, stop bits), and to select between TSIP and NMEA
data output formats.
Specifying GPS Receiver Port Settings
To set up the parameters on the GPS receiver Port Settings
complete the following steps: