Juniper Systems Trimble Lassen GPS Expansion Pod - Manual (Page 6)


Field PC GPS Expansion Pod
Reset Receiver
The Reset Receiver button returns all of the settings on the
GPS receiver to their default setting. This function enables
you to start over in the event that an error was made.
2.
Tap on the Get Settings button and wait approximately
one minute for the settings to appear.
3.
Record the settings for the following:
COM Port: COM3—not changeable
Protocol:
Baud:
Parity:
Data Bit: (Note: Data Bit is always set at 8 and is not
shown in the set up)
Stop Bit:
The following are the default GPS pod settings:
COM Port: COM3 —not changeable
Protocol: TSIP
Baud: 9600
Data Bit: 8—not changeable
Parity: None
Stop Bit: 1
4.
Access the setup or configuration menu in the GPS
program.
5.
Change the parameters on the GIS/GPS configuration
menu of the program to match the default GPS
Expansion Pod settings or change the parameters on