Juniper Systems Allegro DOS Manual - Manual (Page 100)

100 Allegro DOS Owner’s Manual
Example uses of SERPRN are shown below.
Syntax
Serprn com1 9600 n 8 1 x t10
Output
HM/JS Parallel to Serial Redirector
COM1 9600 n 8 1
LPT1 redirected to COM1
Handshaking XON
If the program is called with only the COM port specifi ed, the
program default settings are used.
Syntax
Serprn
com1
Output
HM/JS Parallel to Serial Redirector
COM1 9600 n 8 1
LPT1 redirected to COM1
No Handshaking
If the program is called without any command line parameters, a
status report is shown listing the settings that are currently in use for
the serial port.
Syntax
Serprn
Output
HM/JS Parallel to Serial Redirector
COM1 9600 n 8 1
LPT1 redirected to COM1
Handshaking XON CTS DSR
If the program is called with the ? parameter in the command line, it
returns a list of the available command line parameters.