Juniper Systems Allegro DOS Manual - Manual (Page 93)

Allegro DOS Owner’s Manual 93
Bypassing Individual Commands
If you suspect your problems are related to a specifi c command, you
can view each command individually and bypass only the command
you think may be causing the problems. To review individual
commands, follow these steps:
Reboot the Allegro by pressing the On/Off key for 8 to 10 seconds
(just until the screen clears). After the system starts, DOS displays
the following message:
Starting MS-DOS...
While the text is on your screen, quickly press and release the F8
key. One by one DOS displays each command in your CONFIG.
SYS fi le followed by a prompt. To accept a command, press Y for
yes. To bypass a command, press N for No.
When DOS fi nishes processing the CONFIG.SYS fi le, the
following prompt appears:
Process AUTOEXEC.BAT [Y, N]?
If you also want to view the commands in your AUTOEXEC.BAT
fi le, press Y for yes.
1)
2)
3)