Juniper Systems Allegro CE Manual - Manual (Page 266)

Page 8-28 Expansion Pods
▲ ▲ ▲ ▲ ▲ Bar Code Installation Program
The Bar Code Setup program is installed on your Allegro before it is
shipped. In the event that the Bar Code Setup program gets removed
from your Allegro and needs to be reinstalled, complete the
following steps:
1. Open your CD-ROM drive on your PC.
1. Insert the Allegro CE Utilities CD, which is shipped with your
Allegro, into your CD-ROM drive, close the CD-ROM drive, and
wait for the installation screen to load.
2. Click on the Browse CD button on the installation screen.
3. Double-click on the Utilities Applications folder.
4. Double-click on the Bar Code Pod Setup Install folder.
5. Connect your Allegro to your PC through ActiveSync.
6. Double-click on the setup icon.
7. Follow the instructions given throughout the installation
program.