LABEC M-TIT-5 - Manual (Page 16)

4. Switch on the Meter
Use can connect TIT-5 volume titration panel, mV/pH measuring panel and control panel
together to form the automatic potential titrator, following call meter in short. After mentioned
panels connecting properly, switch on the meter, it can be used now.
When meter is switched on, it starts self-checking and then displays ‘ TIT-5’ automatic potential
titrator’. After a while, the meter starts to check connected titration panel and measuring panel.
When checking finished, the checking result shown as follows:
System checking finished
Present meter is:
Measuring panel … mV/pH
Titration panel …… volume titration
Diag.21 For checking result
If the connection is wrong or connecting line of the meter or the meter itself, meter will reminder
user automatically. Shown as follows. Following is the diag.22 in case the connection of
measuring panel fails. At this time, user should cut off the power, check the connecting line
carefully, if the connection is correct, then the problem maybe from the meter itself., please
contact with our company for help. Of course, user can press ‘Enter’ button to continue, but meter
will limit some operations automatically, which cause user not able to use all functions.
Connection of measuring panel fail
System warning
Enter
Diag.22 Connection of measuring panel fail
When the meter finished self-checking, it enters into measuring status automatically. Shown as
follows is the starting status and all functions of the meter starts from here.
Diag.23 For starting status mV
View Titrate Mode Set Calibrate
100.1
mV
Titrate
25.0
℃
Titration panel READY
+ K 10/21
Feed
Clean
15