LABEC M-TIT-5 - Manual (Page 38)

9.1 Generation of Mode
When titration finished, if necessary, user could generate titration mode, please see chapter
8.1.2 Generation of Mode for details.
9.2 Viewing Mode
User could view and amend relative parameter by viewing the mode generated by himself or the
system mode provided by meter. In starting status, press ‘View’ in menu, select ‘Viewing Mode’
and press ‘Enter’ to view the mode. Displayed as follows:
Mode HC1 → NaOH (0.1)
pH Titration
Number of end point: 1
2003/06/15 00:00:00
First End Point Sample Volume
10.0mL
End Point: 7.00pH
Time Delay:
10s Concentration
of Titrant
End Point Switch: ON 0.1000
PgDn PgUp
Select Mode 01/02
01 HC1 ---﹥
NaOH(0.1)
02 K
2
Cr
2
0
7
---﹥
Fe2+(0.1)
Save as Delete Titrate Stir Calibrate
Diag. 48 Display for Viewing Mode
On the left side is total number of mode and current selected mode, in mentioned diag.48, there are
total two modes and currently user selects No. 1 mode. On the bottom, there are ‘PgUp’ and ‘PgDn’,
user could turn over the page to display the mode.
On the right side is the relative parameter corresponding to selected mode, including Name of
Mode, mV/pH Titration, Number of End Point, Storing Time, End Point Value corresponding
to Each End Point, Time Delay, End Point Switch and Sample Volume, Concentration of
Titrant.
In current page, user could select mode directly, otherwise user could press ‘PgUp’ and ‘PgDn’,
button to display the other modes.
Please refer to chapter 7.3 Mode of Titration for the meaning of each mode parameter. User could
select and amend the parameter depends on actual need.
Note: User could not amend the system mode parameter provided by meter.
In viewing status, user is allowed to save as (copy), delete the mode, of course user is also allowed
to make mode titration. So in viewing mode, user is allowed to set stirring speed, calibrate electrode
slope.
37