OmniSistem Q Scan - Manual (Page 15)

(48) DMX Digital Value DMX Controller Fader 1
Generates a horizontal in-line sequence of 16 beams.
A horizontal sequence of 16 beams is displayed with speed control and Y-axis positional step control and
vertical depth limits from the top.
The 1st fader controls the horizontal size (X Size).
The 2nd fader controls the horizontal sweep speed (X Freq).
The 3rd fader controls the vertical position step size (Y Step).
The 4th fader controls the vertical depth limit from top (Y Depth).
The 5th fader controls the minor x-axis offset (X Offset).
The 6th fader controls the binary beam mask (Beam Mask).
If fader 6 is set to zero then no beams will be shown and if set to max 255 then all beams are shown.
Using the calculator available in most Windows platforms, type the decimal value 170, then convert to binary
as 10101010. The 1's represent beam enables and the 0's are beam disables. Thus 170 enables every
other beam position.
The Binary pattern is repeated once on the left half and again on the right half for a total of 16 beams.
This feature allows specific mirrors to be targeted for various spray effects.
(56) DMX Digital Value DMX Controller Fader 1
Generates a horizontal random sequence of 16 beams.
A horizontal random sequence of 16 beams is displayed with speed control and Y-axis positional step
control and vertical depth limits from the top.
The 1st fader controls the horizontal size (X Size).
The 2nd fader controls the horizontal sweep speed (X Freq).
The 3rd fader controls the vertical position step size (Y Step).
The 4th fader controls the vertical depth limit from top (Y Depth).
The 5th fader controls the minor x-axis offset (X Offset).