OmniSistem Q Scan - Manual (Page 26)

Sound Graphics Editor Continued
This technique is how you rough draw the image desired, then select each point and move it to the desired
location if not already there.
Select the 1st point again. Now click Delete Point button. That point is deleted. This is how you remove
unwanted points.
To add a point to a line, select the nearest point that is part of that line. Then click STACK POINT.
This duplicates that point stacked on top of the original. Now click Move Point.
Move the new point to the desired position. This is how new points are added to a line.
Next, pick a point using Select a Point fader. Notice the motion is defined as still. This is because the motion
multiplier is set to 0.
Click the Multiply button. Each click selects greater motion up to 7. Also notice that as long as the Multiply is
not zero, then the direction select button to the left becomes defined.
As stated before, these graphics are sound sensitive. The sound input provides a raw value from 0 to 14. If
the multiplier is set to 1 and the direction is set to up, then, that point will move from it's current location to a
maximum of 14 units in the UP
If the multiplier is set to 7 then the maximum movement will be 7x14 or 98 in the given direction.
Clicking the Direction button left of the multiply button allows you to choose 1 of 8 possible directions.