OmniSistem Q Scan - Manual (Page 19)

Scenes Section Continued
If the Q-Scan Expansion Set is not attached then the laser defaults to a selection of 1 animation and 7 stills
selected by the group fader 1-8.
See Scenes section and Expansion Set for more details.
There are 4 Text Buttons marked Show Text #. When mouse clicked, the text in the box to the immediate
right is displayed.
If the text has 8 letters or less then the display is stationary, otherwise the message is scrolled.
TEXT BOXES:
Click in a text box. Notice a cursor will appear. You may now Back-Space or Delete using the keyboard to
remove current text.
You can hold the mouse button down and sweep the text line, turning it all blue. Then hit Spacebar to erase
all the text in blue.
Note: Double quotes will be converted to single quotes for disk file structure purposes.
You may type in the text box and click the Show Text button on the left to laser display this text now.
You should place a few spaces before and after the visible text to allow for cleaner laser display if scrolling is
intended.
Only standard text, numbers and most symbols are supported. Lower case alphabet is converted to upper
case by the laser.
Clicking Scene will restore the line to it's original setting. See Scenes section for more details.
Each preset (1-9) can hold 4 unique text lines for a total of 36 lines per file load.