OmniSistem Q Scan - Manual (Page 7)

If you can figure out which one is the Mouse port. DON’T CHANGE IT.
You are trying to enable or move the com port that is NOT assigned to the MOUSE to a vacant position
while avoiding conflict with a modem.
AUTO will usually do the trick except when Phantom Modems are installed.
After making a change and you are sure the only change may be the modem assignment, then exit the
setup program (use F10) normally to save your new configuration. Test if the Laser responds now and the
mouse still works. If you had a modem, try it too. If
Some Systems may work anyway (sort-of) so see if a system conflict may exist back at the "Device
Manager" under Modem or any other devices that may use a comport.
If all else fails...Return the CMOS SETUP to the original values and call the manufacturer. They will be the
most help in re-mapping a com port through the CMOS SETUP screens.
NOTE: Some systems get much more complex with other devices using the com ports besides the mouse
and modem. If you have such then maybe the Manufacturers can help resolve a system conflict. You may
have to buy an A/B switch to select what you want and when
Mode is a generic term that means "To perform an assigned job or task".
To perform a specific task requires the task to be defined and additional parameters (if any) be presented
prior to starting that task.
The function of this program is to provide the user (you) with a simple interface to send these task
commands to the laser unit and supply or modify any additional parameters that may be needed.
Your system supports a huge variety of laser effects such as:
• Volumetric Effects.
Graphic patterns generated using pure math in real time such as circles, stars and spirals.
• Overhead Fans.
Mid-air flat laser light sheets create ceiling effects such as laser sky*.
• Overhead Beams.
Mid-air laser beams that spray and dance with the music.
• Tunnel Effects.
Tunnels can be viewed overhead or on screen with good results but are best viewed from inside the tunnel.
Export only – It is against CDRH regulations 21 CFR 1040 to emit laser >0.39mW into humans.
• True Laser Sky*
Produces a flattened sine wave that imitates a false laser ceiling or the surface of the ocean when fog is
introduced to the effect.