OmniSistem Q Scan - Manual (Page 34)

4. Servicing
Do not attempt to service this system yourself as opening the unit can expose you to dangerous voltage.
Qualified OmniSistem technicians should perform Service only. Opening or removing the cover will void the
warranty.
5. Damage Requiring Service
• Immediately unplug the unit from the receptacle.
• Any damage requiring service as stated above must be reported immediately to
OmniSistem Lights and Effects and an RMA# will be issued.
• The product must be returned in its original packaging.
• Return the unit with ALL components and cables.
• Any damage that occurs do to inappropriate packaging will be repaired at your expense.
6. Laser Safety
Laser can pose an extreme hazard to the eyes and skin!
• NEVER expose eyes by looking directly into the beam no matter what the output level.
• NEVER uses eyes to align the beam by looking directly into the aperture.
• AVOID direct or collateral radiation from the laser.
• NEVER point the aperture of this product in a way that the audience can be exposed to direct or
indirect laser light.
• MAKE sure that all warning labels and product labels remain attached and in there proper place.
There are regulations that must be followed and adhered to when operating a laser system above
1mW.
ClassIIIa 1mw to 4.95mW
All laser radiation must remain 2.5 meters vertically above the floor.
ClassIIIb 5mW to 499mW to ClassIV >500mW
• All Laser Radiation must remain 3.0 meters vertically above the floor and 2.5 meters horizontally
away from human contact. This 2.5-meter rule applies to catwalks, balconies or other raised
surfaces.
• If the system is stand-alone with no operator present double the distances as stated above.
• In the event of a bounce mirror shift, beam turret failure, accidental exposure, scanner failure, or
other anomalous event that falls short of the CDRH guidelines IMMEDIATELY SHUT DOWN YOUR
LASER SYSTEM and do not operate it again until the problem has been remedied.
• Comply with all conditions of your variance. (Variance Regulated Products Only)
• Insure all beams and effects are terminated safely.
• Remember Safety should be your first priority.