OmniSistem Q Scan - Manual (Page 16)

Mode 8 Continued
The 6th fader controls the binary beam mask (Beam Mask).
If fader 6 is set to zero then no beams will be shown and if set to max 255 then all beams are shown.
Using the calculator available in most windows platforms, type the decimal value 170, then convert to binary
as 10101010. The 1's represent beam enables and the 0's are beam disables. Thus 170 enables every
other beam position.
The Binary pattern is repeated once on the left half and again on the right half for a total of 16 beams.
This feature allows specific mirrors to be targeted for various spray effects.
(72) DMX Digital Value DMX Controller Fader 1
Generates 8 different beam patterns that are sound sensitive.
Use the Select1 through Select8 buttons to specify the beam pattern.
The 1st fader selects pattern 1 through 8 (Beams 1-8).
The 2nd fader controls the range of movement by sound volume (Range).
The 3rd fader controls the draw speed (Speed).
(104) DMX Digital Value DMX Controller Fader 1
Generates 8 different fan patterns that are sound sensitive.
Use the Select1 through Select8 buttons to specify the fan.
The 1st fader selects fan pattern 1 through 8 (Fans 1-8).
The 2nd fader controls the range of movement by sound volume (Range).
The 3rd fader controls the draw speed (Speed).