OmniSistem Q Scan - Manual (Page 21)

Typically, you type a sentence, click XferText button, select Xfer#1. Then erase that line and type a new line.
This time select Xfer#2.
The Helper window will show upload status. The upload takes a few seconds because the text must be
written to non-volatile memory.
The Text Mode button is used to browse or display the pre-loaded text lines.
You may click the Text Mode button and select the desired text line to display using Select 1 to 8 or fader
#1.
The cleanest use is to assign the Text Mode as a preset, that way the selected text line and the mode
change are acted upon at the same time.
Changing the selected line is put on hold until the current long scrolling line has completed.
The text mode can be scripted to add text to a show. See Scripting section for more details.
When this program is activated, a file called Preset.ini is loaded automatically. It is identical in format to the
samples.wad file.
A wad file contains all the information such as text, labels and fader settings for all the Mode buttons. With
16 modes and 9 presets, a total of 144 configurations is available from a single wad file.
THE PRESET PAGE and RECORD BUTTONS:
When one of the Record buttons is mouse clicked, the Current Mode and Fader settings are recorded in
temporary memory with the current mode being set as the default for that particular record button used.
The 4 lines of text above is recorded under that record button also.
Before using a Record button, click the Sync button to see how the recorded presentation will appear when
restored later.