Canon BJC-55 - Manual (Page 36)

What you need for infrared data transmission
You can use the infrared interface with Windows 95, Windows 98, or
Windows 2000. However, in order to use the infrared interface, your
computer should meet the following requirements.
If you are using Windows 95, you need IrDA 1.0 with a maximum baud
rate of 115.2 kbps, and the Microsoft infrared port driver version 2.0.
Confirming that the infra-red transmission driver
has been installed
Follow this procedure to confirm that the infra-red transmission driver
has been installed.
1.
Click the Start button, point to Settings, and click Control Panel to
open the Control Panel window.
2.
Look at the Control Panel window and confirm that the Infrared
Monitor icon is displayed.
If the Infrared Monitor icon is displayed, the required infra-red
transmission driver has already been installed.
If the Infrared Monitor icon is not displayed, refer to your Windows
manual for instructions on installing the infrared port.
If you are using Windows 95 and the Infrared Monitor icon is not
displayed, close the Control Panel window and follow the procedure
below.
34 Chapter 2 Setting Up the Printer
Computer IBM PC/AT or a compatible computer
CPU
IrDA IrDA 1.1 or later
Infrared transmission device Built-in infra-red port on the computer,
or an infrared transmission adapter
connected to the parallel or serial port.
Operating system Windows 98/Windows 2000
Baud rate
(transmission speed) Max. 4 Mbps
Intel Pentium or faster