Canon BJC-55 - Manual (Page 52)

4.
Slide the paper guide
➊
to the mark for the size of the media you
are loading.
5.
Hold the sheet with the print side up and align the left edge of the
sheet with the stopper
➋
on the left side of the front cover.
6.
Insert the paper straight into the printer
➌
(about 5 cm) until it
stops. Push the sheet in slightly and hold it in place for about two
seconds. The sheet will feed partially into the printer.
• If the sheet is too narrow (less than 100 mm), or if the sheet is inserted
diagonally, the buzzer will beep once, the CHARGE/ERROR lamp will
flash, and the printer will eject the paper from the feed slot. After the
sheet is inserted again correctly, the printer will reverse feed it slightly
and the buzzer will not beep. If POWER lamp is flashing, data remains
to be printed. Press the RESUME button to finish the print job.
• If the POWER lamp lights and remains on, remove the sheet and then
load it again.
7.
Start the print job with your software application.
A4
2
1
3
50 Chapter 3 Printing
Paper guide
Mark for the size
Stopper