Canon DR-1210C - Manual (Page 47)

Using the Scanner 43
Chapter 2
3.
If the jammed document shows no abnormalities, such as ripped paper, close
the feeder cover and press [STOP].
The jammed document is ejected, and the error message display is cleared.
4.
If the jammed document is skewed or ripped, carefully remove it manually.
Take care not to rip the paper.
IMPORTANT
• If you are removing the document manually, make sure to remove the
document carefully, by pulling on it steadily and without applying too much
force. Should the paper tear, make sure to remove any torn pieces remaining
in the scanner.
• To remove a document from the supply side (the back of the feeder), raise
the paper release lever (c) and then carefully remove (d) the jammed
document. Be sure to return the paper release lever to its original position
(
e ) after you remove the jammed document. If the paper release lever is left
in the raised position while scanning, it may cause two pages to be scanned
at one time.
STOP button
Paper release lever
DR-1210C.book Page 43 Monday, December 19, 2005 10:35 AM