Canon DR-1210C - Manual (Page 49)

Using the Scanner 45
Chapter 2
5. Scanning Hints
This section describes helpful hints for setting up and using your scanner.
Refer to these hints when you set up the ISIS/TWAIN Driver. For more details
on items not described in this section, see “Software Settings,” on p. 49.
Flatbed (Platen Glass) Scanning
• I want to scan on the flatbed
Set the Paper Source setting to [Flatbed] or [Auto]. When Paper Source is set
to [Auto], a document placed on the flatbed is scanned if there is no
document on the feeder.
See “ISIS Driver Settings g,” on p. 50, and “TWAIN Driver Settings g,”
on p. 52.
Scanning Non-standard Size Documents
• I want to scan non-standard size documents
When a non-standard size document is scanned with a standard size
specified, a black margin around the scanned image. If you want to scan non-
standard size documents, set Page Size to [Auto-detection]. The size of the
document is automatically detected.
See “ISIS Driver Settings c,” on p. 50, and “TWAIN Driver Settings c,”
on p. 52.
• I want to register non-standard size documents
A non-standard document size can be registered as a Custom Paper Size.
See “ISIS Driver Settings l,” on p. 50, and “TWAIN Driver Settings l,”
on p. 52.
• I want to scan only part of a document
The scan area can be specified before scanning. Note, however, that the scan
area cannot be specified when Page Size is set to [Auto-detection].
See “ISIS Driver Settings m,” on p. 50, and “TWAIN Driver Settings m,”
on p. 52.
DR-1210C.book Page 45 Monday, December 19, 2005 10:35 AM