Canon DR-1210C - Manual (Page 75)

Appendices 71
Ch
ap
te
r 3
[Warming up] Is Displayed When Scanning
Because the DR-1210C uses a cold cathode fluorescent lamp (CCFL) as its
light source, it is necessary to wait until the output from the lamp stabilizes
before scanning. [Warming up] is displayed until the lamp turns on and its
output is stabilized after the scanner’s power is turned on or when the scanner
comes out of the power saving feature. The length of time that [Warming up] is
displayed varies depending on the conditions of the lamp.
Setting the [CCFL Control]
The DR-1210C’s default settings are set to turn off the lamp when the scanner
enters the Power Saving Feature after no operations have been done for 12
minutes. Because of this, if more than 12 minutes elapses between scanning
jobs the lamp turns off and [Warming up] is displayed the next time scanning is
done.
If the period between scanning jobs is longer than 12 minutes you can use the
[CCFL Control] to change the time before the scanner enters the Power Saving
Feature so that [Warming up] is not displayed when scanning is done.
Set the [CCFL Control] in [Scanners and Cameras Properties]. Follow the
procedure below to change the settings.
Use the following procedure to open the [CCFL Control] settings dialog box.
1.
Use the following procedure to open the [CCFL Control] settings dialog box.
1. Click the [Start] button, Æ click [Settings] on the Start menu Æ click
[Control Panel]. (For Windows XP, click the [Start] button Æ click [Control
Panel].
DR-1210C.book Page 71 Monday, December 19, 2005 10:35 AM