XMART Optima 10K 2PH - Manual (Page 44)

User Manual
- UPS ONLINE 6K/10K 2Ph
ENGLISH
_____________________________________________________________________________________________________________________
20140714_ 6K-10K 2PH (EN) - 44
ALARM SYMBOLS ON LCD
ALARM DESCRIPTION BEEP/Sec
LOW BATT. Low Battery 1 beep / s
OVER LOAD
UPS Overload: High power consumption in Watts at
UPS output
2 beep / s
BATT. FAULT Batteries disconnected 1 beep / s
EP
EPO (emergency power off) activated 1 beep / s
High Temperature 1 beep / s
Battery Charger Failure 1 beep / s
Input Fuse Activated 1 beep / s
Repetitive Overloads Detected (3 in 30 minutes) 1 beep / s
3F
Parallel Failure (**) 1 beep / s
FLASHING ICON
Battery Overload 1 beep / s
ACOUSTIC BEEP
Description Buzzer status Muted
ESTADO
Bypass mode
Beeping once every 2 minutes
Yes Battery mode Beeping once every 4 seconds
Fault mode Beeping continuously
ALARM / WARNING
Overload
Beeping twice every second
No
Low battery
Beeping once every second
Battery unconnected
Over charge
EPO enable
Fan failure/Over temperature
Charger failure
IP fuse broken
Overload 3 times in 30min
EPO status
FAILURE / ERROR
All failures and Error states
Beeping continuously Yes