YSI 5200A - Manual (Page 16)

YSI 5200A
31
YSI 5200A
30
1. See Open Front Panel to Access I/O Board - page 38 to remove front
panel from 5200A enclosure.
Figure 3.4
2. Disconnect front panel ribbon cable by pressing the two IDC header
connectors located on the front panel out (away from the IDC header)
- figure 3.5.
Figure 3.5
Installation and Wiring
3. Remove and retain the four screws that secure the display board into front
panel enclosure - figure 3.6. (The display board is mounted on panel that
is attached to 5200A front panel. The I/O Board wiring diagram is located
on the display board panel.)
figure 3.6
4. Carefully lift out the display board and remove the lanyard from the display
board panel - figure 3.7. Set display board panel and front panel aside.
Figure 3.7
5. Fasten the mounting brackets to the back of the 5200A enclosure with the
mounting screws - figure 3.2, page 28.
6. Tighten the screws, securing the brackets to the 5200A.
7. Drill a hole in the panel for 5200A enclosure (dimensions provided with
kit).
Installation and Wiring