Accessing the i/o board, Open front panel to access i/o board – YSI 5200A User Manual

Page 20

Advertising
background image

YSI 5200A

39

YSI 5200A

38

diameter. Some pre-drilled rubber grommets are supplied with the 5200A.

Figure 3.13

Accessing the I/O Board

The I/O board is accessible when the 5200A front panel is removed. The letters

on the metal plate, which is attached to the lower board assembly, identify ground

wire termination locations and pluggable terminal strip locations on the I/O board.

Letters on the metal plate correspond to the wiring diagram located on the inside of

the front panel - figure 3.14. A ribbon cable connects the display board (mounted

in the front panel) to the I/O board. When the 5200A front panel is removed, a

lanyard protects against stress on the ribbon cable. See Open Front Panel to Access

I/O Board - page 39.

Installation and Wiring

Figure 3.14

Open Front Panel to Access I/O Board

WARNING: Disconnect external power to the unit before doing any wir-

ing.

AVERTISSEMENT : déconnectez l’alimentation externe de l’unité avant

d’ouvrir le panneau avant.

1. Loosen the 4 mounting screws connecting the front panel to the back

enclosure. Captive screws remain in front panel after loosening.

2. Carefully lift the 5200A front panel from the back enclosure. Front panel

should be placed to the left of enclosure. Allow the lanyard to hold the

weight of the front panel. The rubber gasket seated in the front panel

should remain in the front panel lid.

Installation and Wiring

Advertising