YSI 5200A - Manual (Page 64)

YSI 5200A
127
YSI 5200A
126
1. Use
▲
and
▼
to scroll and highlight submenus.
2. Press

to select.
3. When prompted, “Are you sure?”, select one of the following to confirm,
4. Press to save configuration and return to Run Screen.
Reset Sensors
Menus → System → Service→ Reset To Factory→ Reset Sensors
Specific sensors, aux system, or all sensor and aux systems listed in the Reset Sensors
menu can be reset to factory default.
1. Use
▲
and
▼
to scroll and highlight submenus.
2. Press

to select.
3. When prompted, “Are you sure?”, select one of the following to confirm,
4. Press to save configuration and return to Run Screen.
Note:
- Perform a sensor calibration after resetting a sensor to factory default.
Configuring the 5200A
Reset Timers
Menus → System → Service→ Reset To Factory→ Reset Timers
A specific timer, feed timer, or all timers listed in the Reset Timers menu can be
reset to factory defaults.
1. Use
▲
and
▼
to scroll and highlight submenus.
2. Press

to select.
3. When prompted, “Are you sure?”, select one of the following to confirm,
4. Press to save configuration and return to Run Screen.
Relay Test
Menus → System → Service→ Relay Test
Use the Relay Test menu to verify peripheral devices are wired correctly. Entering
this menu turns off any active relays and disables any sensor, aux, and timer system
relays from energizing regardless of value or condition. Systems are not reset when
the Relay Test menu is exited. To reset systems after exiting the Relay Test menu,
power cycle the 5200A. Example - an energized conductivity low control relay (set
point control normal mode) is de-energized when entering the Relay Test menu. If
the conductivity value is in control low range when the Relay Test menu is exited,
the relay will not re-energize until the system has a change of condition. The con-
ductivity system must reach set point, then fall in low control range again before
energizing the control low relay. It is strongly recommended to turn the power off,
then on, at the 5200A after exiting the Relay Test menu.
Configuring the 5200A