Changing presser feet, Snap-on presser feet, One-piece presser feet – SINGER 1030 Creative Touch User Manual
Page 10: The button foot
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING PRESSER FEET
Snap-on Presser Feet
Most of the presser feet furnished with your
machine snap on and off a common shank.
1. Raise take-up lever to its highest position
by turning the hand wheel toward you.
2. Raise presser foot.
3. Press toe of presser foot upward (as far as
it will go) and then snap down to remove.
4. Center the new presser foot under the
shank and lower the presser-foot lifter so
that the shank fits over the presser-foot pin.
5. Press presser-foot screw down until foot
snaps into place.
To remove and replace the shank of snap-on
presser feet, follow instructions below for one-
piece presser feet.
One-piece Presser Feet
1. Raise take-up lever to its highest position
by turning the hand wheel toward you.
2. Raise presser foot.
3. Loosen presser foot screw and remove the
foot guiding it to the right.
The Button Foot
• Hook button foot around the presser bar and
tighten presser-foot screw.