SINGER 1030 Creative Touch - Manual (Page 32)

By using a twin needle, you can produce
simultaneously two parallel, closely spaced
lines of straight or zig-zag stitching. Effective
for decoration, twin-needle stitching is not
recommended for seams or for use on knits.
Soft fabrics should be sewn with a paper or
fabric backing.
preparation
1. Clip detachable spool pin to guide post as
shown.
2. Thread machine as instructed on page 9,
making certain thread passes on right side
of tension disc.
3. Wind bobbin with enough thread to com­
plete stitching. (Since a bobbin cannot be
filled after a twin needle is inserted, it is
wise to keep an extra wound bobbin at
hand for replacement.)
NOTE: When inserting a previously wound
bobbin, follow the instructions on page 13.
4. Close slide plate and raise bobbin thread.
5. Cut thread about four inches from needle,
and unthread the needle.
6. Remove the single needle and insert the
twin needle.
threading the needle
1. Pass thread through right eye of needle.
2. Place spool of thread on detachable spool
pin and thread machine as for one-needle
stitching except:
• Pass thread on left side of tension disc.
• Thread through remaining points making
certain to omit the thread guide above the
needle and pass thread through left eye
of needle.
r’ !■
26