Replacing a wound bobbin – SINGER 1030 Creative Touch User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Replacing a Wound Bobbin

REPLACING A WOUND BOBBIN

Raise take-up lever to its highest position.

1. Open slide plate; move bobbin latch all the

way to the left.

2. Draw about an inch of thread from bobbin

and place bobbin in case.

3. Pull thread into bobbin-case slot (point 1),

draw it under flat spring and around to (or
slightly past) point 2, leaving two or three

inches of free thread. (Leave slide plate

open.)

RAISING THE BOBBIN THREAD

Set stitch width dial at .

1. Move bobbin latch to right (sewing posi­

tion). Hold needle thread lightly with left

hand and turn hand wheel slowly toward

you so the needle enters plate.

2. Continue turning hand wheel and holding

needle thread until needle rises. Tighten

your hold on the needle thread and bring

up bobbin thread in a loop.

3. Open the loop with your fingers, draw nee­

dle and bobbin threads under the presser
foot and place them diagonally to right or

left. Then close the slide plate.

Insert Bobbin

Flat Spring

Draw Thread
Under Flat Spring
Around to Point 2

Raising the Bobbin Thread

Step 2

Step 3

13

Advertising
This manual is related to the following products: