SINGER 1030 Creative Touch - Manual (Page 16)

USING THE NEEDLE THREADER
The needle threader may be purchased sepa­
rately at your local Singer Sewing Center.
Thread the machine in the usual way up to the
needle, then follow the instructions below.
Turn hand wheel toward you to raise needle
to its highest position.
Lower the presser foot.
. Holding the needle threader by its tab with
the right hand, position U-shaped part of
threader under bar of needle clamp. Snap
threader up onto bar.
Slide threader over to left, as far as it will go.
I. Swing threader back just far enough to
clear the needle. Align metal hook of
threader with the eye of the needle.
Swing threader forward so that hook passes
through eye of needle.
3. Holding approximately 3 inches (7.6cm) of
thread between your hands, loop thread
under metal hook. Leave slack in thread on
each side of hook. Release thread.
4. Holding threader by its tab with right hand,
draw metal hook and thread back through
eye of needle.
•
• Slide threader to the right off bar of needle
clamp. Carefully unhook thread from needle
threader.
10