Winding the bobbin, Preparation steps, Winding steps – SINGER 1263 User Manual
Page 19: The bobbin thread
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The Bobbin Thread
Winding the Bobbin
Preparation Steps
1, Raise the presser foot and turn hand wheel toward
you until needle is in highest position.
Z Loosen hand wheel knob A by turning it toward you
with the right hand while holding hand wheel with
the left hand.
3. Place thread spool on spool pin with thread retain
ing slit B on top. (Break paper at the end of spool if
necessary.)
Winding Steps
• Lead thread around bobbin winder tension disc C,
as illustrated, and through small hole in bobbin from
inside out.
• Place bobbin on spindle and move bobbin winder
D to right.
• Hold thread end and start the machine. Cut off
thread end after a few colls have been wound.
• When required amount of thread has been wound
(winding will stop when bobbin is full) stop machine
and cut connecting thread.
• Move bobbin winder to the left and remove bobbin.
• Hold hand wheel and tighten hand wheel knob.
18