Sewing a seam – SINGER 1263 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sewing a Seam
1. Select straight stitch and set the stitch length dial
on desired setting. Raise presser foot. Pull thread
back under presser foot leaving at least 10cm
(4 inches) of thread.
2. Position needle approximately 1.3cm (1/2 inch) from
fabric edge. Then lower presser foot and backstitch
almost to the edge of the fabric for reinforcement
by stitching in reverse direction. For additional in
formation on reverse stitching refer to page 26.
Stitch forward to end of seam and stop machine
before the end of stitching line. (Do not sew beyond
edge of fabric.)
CAUTION: Do not pull the fabric while you are
stitching as this may deflect the needle causing it
to break.
3. Raise needle by turning hand wheel toward you.
Press reverse stitch push button, and back stitch
1.3cm (1/2 inch) to reinforce end of stitching.
4. Raise needle by turning hand wheel toward you.
Raise foot and remove fabric by drawing it to the
back and to the left. Cut threads on thread cutter at
rear of presser bar.
30