SINGER 201K User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO OIL MACHINE and STAND
K4S3d
Fig, 27, Front View, Showing
Oiling Points,
The Arm Spool Pin C is screwed for
insertion in the left plugged hole and it
is also provided with a screw driver slot.
If the machine is used continuously, it
should be oiled daily. If moderately
used, an occasional oiling is sufficient.
Apply one drop of oil to each of the
places indicated in Figs. 27, 28, 29, 30 and
31 and carefully clean the machin e to
insure smooth and satisfactory perform
ance. Oil holes are provided in the
machine for bearings which cannot be
directly reached.
Remove face plate A, Fig. 27, by taking
out screw B and slipping plate over screw
D, Fig. 28. After oiling replace face plate.
Draw to the left the slide in the bed of the
machine, as shown in Fig. 27, while the
27