SINGER 201K User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ELECTRICAL INFORMATION
The SINGER* Electric Motor
is located at the back of the machine,
and can be supplied for operation on
alternating or direct current. Orders
must state the catalogue number of the
motor, or the voltage, and in the case of
alternating current, the number of cycles.
Before Inserting Electric Plug—
be sure that voltage and number of
cycles stamped on motor nameplate
are within range marked on electric
meter installed by electric power company.
Electrical Connections for Machine
Push three-pin safety plug into three-
pin terminal block at right of machine
and connect plug at othei end of cord
to electric supply point.
Speed Controller
The speed of machine is regulated by
amount of pressure on foot controller
or knee controller.
CAUTION
When you have finished your sewing always dis
connect the plug from the electric supply point.
■fe