SINGER 201K User Manual
Page 58
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
THE ADJUSTABLE HEMMER
To Make Hems
from 3/16 to 15/16 Inch Wide
1. Attach adjustable hemmer to presser
bar in place of presser foot,
2. Pull up bobbin thread as instructed
on page 19.
3. Loosen thumb screw on hemmer and
move scale until pointer registers
with number of desired width of hem.
(No. 1 indicates the narrowest hem
and No. 8, the widest.) Then tighten
thumb screw.
4. Place cloth in hemmer and draw it
back and forth until hem is formed
as shown.
5. Draw end of hem back under needle,
lower presser bar and start to sew.
6. Guide sufficient cloth into hemmer ta>
turn hem properly.
56
Advertising