SINGER 201K User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig* 30* Oiling Points in Bed of Machine.
Fig. 31.
To oil the parts underneath the bed of the machine, turn the machine back on its hinges and
apply oil to the oil holes and bearings indicated in Fig* 30* The gears concealed by the gear
cover (E2, Fig. 30) are oiled through the oil hole (E, Fig. 27), The gears concealed by gear cover
(D, Fig* 30) are oiled through the space just above this cover, as indicated hy arrow (D2, Fig. 31).
After oiling at D2, rotate the hand wheel toward you to distribute the oil on these gears. To
oil the stand, apply a drop of oil to the centres upon which the treadle works, and to the lower
end of the pitman rod. Run the machine rapidly for a few minutes so that the oU may reach
the bearings. Neglect to oil the machine will shorten its life and cause you trouble and annoyance.
Always use SINGER* oil. Inferior oil clogs the bearings, prevents efficient working, and causes
rapid wear of the mechanism.
29