SINGER W426 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WINDING BOBBIN
Disengage the hand wheel (1) frpm
the stitching mechanism by turning
the clutch nut (2) toward you or
counter-clockwise.
Place a spool of thread on one of
the spool pins and lead thread
through the rear Top Thread Guide
(3) after hooking on Bobbin Winder
Tension Disc •
Run the end of thread through a
hole in the bobbin edge and place
bobbin on spindle of bobbin winder
(4) fitting the notch on bobbin over
small spring click on spindle.
Push bobbin winder (4) to the
right, and hold the thread end
loosely then start machine slowly.
Bobbin will stop winding when it is
filled. Push bobbin winder (4) to»
the left.
Turn clutch nut away from you
until sewing mechanism is again
engaged so that needle moves when
you turn the hand wheel.
Break off loose thread end used to
start the winding and cut other
thread end. Then remove bobbin
from bobbin winder.
12